![]() ![]() ![]() Grub just runs normally, there is nothing in advanced options for starting ubuntu either, just the usual different kernel versions.Īny idea why MokManager just does not start at boot? I mentioned my enryption setup because I am wondering if that is the issue. ![]() I tried this several times, once after running sudo mokutil -enable-validation, every time the MokManager is not present at boot. I tried both independently, so I made to MOK.der certificates, and then ran mokutil -import MOK.der followed by immediate reboot. Those following the OpenMoko commitlog will have noticed quite a bit of activity in the areas of u-boot and kernel patchset. I would ideally like to use secure boot on Ubuntu as well, but I am a virtual-box user, which means I have to sign the kernel modules. ago That would be correct, the U2C works out of the box, there is no need to touch its firmware. Right now, when switching between the two OSes, I have to enter the bios to toggle secure boot on and off. After the module is completely powered off, press and hold the Boot button, plug the Type-C data cable to power the module, enter the DFU mode, and use the STM32CubeProgrammer software to update the firmware. U-Boot's commands are actually generalized commands which can be used to read or write any arbitrary data. device tree or ramdisk image) into memory, and then executing the kernel with the appropriate arguments. My laptop has two hard drives, one with windows 10, encrypted with bitlocker, and the other with Ubuntu, with LUKS full disk encryption. U-Boot boots an operating system by reading the kernel and any other required data (e.g. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |